2” PVC Fittings

Inside Pipe Repair Glues Inside 2" Pipe and allows a 2" Slip to be glued over or a 1 1/2" Slip to be glued inside. Magic Mend Simply cut the bad fitting off of 2" hard pipe and remove it from the system. Glue the 2" Spigot Street end of the Magicmend...

This part is a (2) 90° 2" Street X 2"Slip PVC Plumbing Fitting. The 90° ELL receives a 2" fitting on one side which would measure 2 3/8" and then slips into a 2" fitting on the other side. It will Glue into any 2" fitting to make a...

Inside Pipe Repair Glues Inside 2" Pipe on both ends. Magic Mend Simply cut the bad fitting off of 2" hard pipe and remove it from the system. Glue the 2" size Magicmend in between two peices of 2" ID pipe to mend pipe back together

This part is a Bushing Reducer 2" Street x 1 1/2" Slip converts a 2" glue in fitting into a 1 1/2" Glue In Fitting. For example you can install a 2" manifold in place of 1 1 1/2" Manifold by gluing this on the 1 1/2" pipe and gluing it inside of a slip...

Inside Pipe Repair Glues Inside 2" Pipe & into 2"spg Fittings Magic Mend Simply cut the bad fitting off of 2" hard pipe and remove it from the system. Glue the 2" size Magicmend into the pipe and replumb your new fitting

This part is a (1) 2" Slip X 2"Slip Coupler PVC Plumbing Fitting. The Coupler receives a 2" fitting which measures 2 3/8" OD on one side and then receives a 2" fitting which measures 2 3/8" OD on the other side. The inside diameter of...

This part is (1) 45 Degree 2" Street X 2"Slip PVC Plumbing Fitting. The Union glues into a 2" fitting on one side and then receives the fitting on the other side. It will Glue into any 2" fitting to make a tight plumbing application. The inside diameter...

This part is a 2" Street X 2" Slip X (4) 3/4" Barbs manifold and a single barb plug in case you only need 3 barbs instead of 4. The Manifold receives a 2" pipe on the slip side which would measure about 2 3/8" outside...

This Kit is a 12' Long RADKit® designed to go onto the outside of a 2" fitting and seal off the area between (2) 2" Fittings Outside to Outside.. An example would be if you had a Suction fitting dripping at the glue joint and there is a piece of 2"...

This kit is a 6' Long RADKit® designed to go onto the outside of a 2" fitting and seal off the area between (2) 2" Fittings Outside to Outside.. An example would be if you had a Suction fitting dripping at the glue joint and there is a piece of 2"...

This part is a 1-1/2" Slip (2"Spigot) on each end Clear Check Valve found on Watkins Hot Tubs HotSpring 1989 To Present and All Tiger River Models..   

This part is a 12" Piece of 2" Flex Pipe used with manifolds, slice valves or unions... The outside of this pipe measures about 2 3/8" Outside Diameter..       740016011378,DW-17ST R , DW-17ST-ZD,89-555-1105,1.062",hose...