Shop

OEM TheraFlo 1.5 HP, 2 speed pump assembly with baseless motor. Used in entry level Jacuzzi, Sweetwater and Sundance spas that utilize the unique pump bracket that straps around the motor. This pump assembly can be mounted and adjusted to accommodate...

This part is a Direct replacement sensor kit for Watkins No-Fault 4000 or 6000 heater.Includes: Temperature Sensor, Hi-Limit Sensor, and (2) Two rubber O-Rings with newer Style Connectors 2002+.  Sensor Application Spa Control Sensor Type Temp...

Dynasty Replacement Heater.Vertical heater assembly, 3" x 11" with 3/4" barb x 3/4" 90&deg barb inlet/outlets, 5.5kW/240v I have one of these left..  NO Longer Available Note: Therm Products the manufacturer of most hot tub heaters has gone out...

We are offering a Cartridge Filter 9 1/4" Tall x 6" Wide 2"mpt 40sqft and fits newer Master Spa Legend and Twilight Series tubs as a replacement for the Microban filter previously used.  This cartridge is comparable to the Master Spa X268543...

This pump is a rated 5HP Viper 2 1/2" x 2 1/2" 56 Frame Spa Pump... The measurement from the edge of the thread to the edge of the thread on the Suction and Pressure side is 3 11/16"..  It is an unusual pump not found in most hot tubs.. It is...

This pump is a rated 4HP Viper 2 1/2" x 2 1/2" 56 Frame Spa Pump... The measurement from the edge of the thread to the edge of the thread on the Suction and Pressure side is 3 11/16"..  It is an unusual pump not found in most hot tubs.. It is...

This 5 3/4" Inside Diameter O-Ring fits around the face of a Waterway HI-Flo 48 Frame Wet End all Horsepowers and fitting sizes... This is (1) O-Ring ONLY!! As you can see below it fits other pumps and filter housings as well.. Part...

This part is a PC Board Plastic Standoff Holder Kit 1/4" long, Reverse Lock Style, Pack of 12, Fits Balboa and some other Brands...  We also have the 3/4" Version Here: Click for 3/4" Standoff Kit 

This part is a PC Board Plastic Standoff Holder Kit 3/4" long, Reverse Lock Style, Pack of 12, Fits Balboa and some other Brands...  We also offer the 1/4" version of this part: For the 1/4" Standoff Kit Click Here

This part is a Stationary Switch, Century, Wishbone, 2 Speed, Pump, Motor, Switch.. The thing that happens to this switch is one of the phenolic pads on the edge of the wishbone falls off and the motor will not start in low speed because the wishbone...

Manifold Wye Full Description Features: 22.5 degree wye 1 inch slip X 1 inch slip X 1 inch slip The slip fitting on this part would measure about 1 1/4" Inside Diameter on each opening.. Improves performance Available in two different...

This 230V Laing E-10 pump with internal Flow Switch.  Has a 1" Barb Suction and Pressure Side hich measures about 1" Outside Diameter and the hose is 1" Inside Diamater  is compact and lightweight, less than 5 lbs. It is whisper quiet, highly...