Electronic Control Systems and Parts

Plug End Rainproof GFCI (15amp)14-3 SJTW 15` long cord plug end GFCI GFCI Type    Power CordMounting    Cord MountGFCI Amperage    15AGFCI Style    Single Pole Single Throw...

Right Angle GFCI PlugDesigned for protecting spa units- keeps cords snug against the wall. Provides ground fault and open neutral protection

Harwil Q12DS Flow Switch 1/2" NPT2 amp pilot duty switches on at 10 gpm and switches off at 8 gpm. ABS body, stainless spring armKit includes one each 60-555-1225, 1/2" strain relief connector&one 1/2"fpt x 1/2"fpt coupling.Stationary arm measurements:2"...

This part is a 31" AMP Style 4 Wire Cord With Male Plug that is used on a 2 speed pump.. The Wire colors are as follow on most systems: Red=High Speed Black=Low Speed White=Neutral or Common Green=Ground There are exceptions to these colors versus speed...

Temperature Sensor This sensor is used with Some Jacuzzi Premium Hot Tubs and the following Sundance systems: 1992 Suncoast, 1996-98 Suntub, 1997-2005 400, 600, 600-S, 750, 800, 1997 850, and 2005+ 880 series Usually this Temp Sensor is bad when it gives...

Sundance Jacuzzi Flow SwitchWith transparent tee fitting; fits all 6/99- present 1-pump systems (except 2001–present Capri) 2 Barbed with Box End Connectors without PlugAdditional Details:-Flow Switch with Transparent Tee Fitting-SPST Contact...

This part is a 4 pin female side Amp connector 20 Amp . This part is normally found on the control pack side mounted for the male amp cord that would come from a pump or blower or other accessory. Note: You will need a pin tool to replace this part to...

This Item is a 20Amp Slo Blo MDA Style Ceramic Fuse that measures 1 1/4" Long x 1/4" Wide and is used on some Hot Tub or Pool Boards. This is a smaller automotive style fuse that does not have glass but used ceramic to dissipate heat. You will not be...

This is a Balboa Temperature & Hi Limit Combination. This is a standard part and fits most Balboa 4 pin applications that are no M-7. It features a 4 pin connector will Curley Finger style ends and the Temperature Sensor Cable is 96" long and the Hi...

This Item is a 30Amp Slo Blo MDA Style Ceramic Fuse that measures 1 1/4" Long x 1/4" Wide and is used on some Hot Tub or Pool Boards. This is a smaller automotive style fuse that does not have glass but used ceramic to dissipate heat. You will not be...

This Item is a 3/4" Threaded Flow Switch with Housing that is found in Jacuzzi Premium, Sundance Spas and a Few other Brands. The Housing is 3/4" Barb X 3/4" Barb X 3/8" Barb. Note: Some housings don't have the 3/8" Barb if yours doesn't you need to find...

This part is a Balboa Heater M7 Sensor. This Sensor comes with the wire, Connector, and The Screw down cap. It DOES NOT include the tube and the tube side mount. You will normally not need the sensor mount you would reuse it so there is no reason to have...