Electronic Control Systems and Parts

Waterway NEO 2100 ETS (Electronic Thermal Sensing) Temperature Sensor. Similar to Balboa's M7™ Technology, the NEO 2100 uses (2) ETS sensors to determine the water temperature.     Sensor Application Spa Control Sensor Type...

This part is a GRAY Balboa Temperature Sensor Mount that accommodates 3/8” temperature sensors from Balboa, Gecko, Hydro Quip, and others. 1” hole size required. Thermowell Type Thru-Wall Sensing Bulb Size 3/8" Thru-Wall Hole Size 1"

This part is a 2 Terminal 50Amp Power Block found on many Control pack and board set ups..

This part is a Pressure or Flow Switch for a Hayward HeatPro Pool Heater.. some of the heater model numbers this fits are HP20654T, HP21104TC, HP21404T, HP21124T..  

This part is a Temperature and Hi-Limit Sensor that fits some ACC SmartTouch control systems there is one sensor bulb is 1/4" Diameter and it uses (2) 2-pin connectors.. Fits most ACC Smartouch and Epack control systems regardless of year.

This part is a Temperature and Hi-Limit Sensor that fits some ACC control systems the cable is 20" long and the sensor bulb is 1/4" Diameter and it uses a 2-pin connector.. Fits ACC Smartouch and Epack control systems regardless of year.

This part is a Used New Style 3 Lug Terminal Block found on many Balboa Brand Spa Hot Tub Boards. This terminal Block can get burned on one or two legs and if the soldered on finger terminals are good on the board you can replace this part and not buy a...

This part is a Pressure Switch Cable that is 7" long and Universal for use on most SSPA, MSPA, T-MSPA, and some Hydroquip boards..

This Item is a Board Fuse .05Amp Slo Blo MDA Style Ceramic Fuse that measures 1 1/8" Long x 1/4" Wide and is used on some Hot Tub or Pool Boards. This is a smaller automotive style fuse that does not have glass but used ceramic to dissipate heat. You...

This part is a Terminal Block 6 Position 40A 115 or 230V.. that fits Balboa Duplex Digital and Super Digital Board System with (6) Tabs to connect the board to the components.. 6 position terminal block 5-3/16" overall length.

This part is a Electronic Pressure Switch for Watkins Solana, Caldera & Hot Spot, 2006 Thru Current that features 1/8th" MPT Standard Threads and 2 pin connectors for attaching the 2 wire 3 hole connector for a Watkins board. What goes...

This item is a 1/8" MPT Plastic Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole...