Description
Please Note: Only One Threaded Drain/Bleeder Port
The original Aqua-Flo XP2/XP2e wet end faceplate had 3 threaded drain/bleeder holes. Newer wet ends now come with only one threaded port. The other holes are molded into the plastic but do not have threads cut into them. If your installation needs more than one connection, you will need to tap the extra hole(s).
The Aqua-Flo XP2e pump wet end uses 1/4"-18 NPSM straight pipe threads for the drain plug opening. To add the threads, you will need a 1/4"-18 NPSM straight pipe thread tap. Carefully cut the threads by hand, keeping the tap straight and backing it out periodically to remove plastic shavings. Do not overtighten the drain plug when installing it.
Important: Use an NPSM straight-thread tap, not an NPT tapered-thread tap. The original drain plug uses an O-ring to create the seal.
This component is a Complete 1.5HP Aqua-Flo 2" x 2" (approximately 3" across thread diameter) side discharge 48 frame wet end assembly designed for XP2 pump systems. This wet end assembly pairs with a 48 frame motor operating at approximately 9.0 Amps high speed on 230V or 13.0 Amps high speed on 115V using 1/4" thru-bolt configuration. Compatible motors include both single and dual speed variants. The discharge position can be adjusted by rotating the wet end 90 degrees. This full assembly contains: volute housing, mechanical seal, impeller, wear ring, suction cover, suction cover o-ring, drain plug, drain plug o-ring, and mounting screws for suction cover.
For connecting a small diameter hose to the front wet end face, consider these barb fitting options with or without sealant. Silicon sealant is highly recommended for these fittings as pipe tape performs poorly:
Barb Adapter, 3/8"b x 1/4"mpt, Pump Wet End Face fits Aqua-Flo & CMP
Barb Adapter, 3/8"b x 1/4"mpt, With Silicon Kit Pump Wet End Face fits Aqua-Flo & CMP
Important: Always select horsepower rating based on motor amperage using the reference chart below. A 48 frame motor diameter measures approximately 5 1/2" across with 1/4" thru-bolt heads and roughly 5 3/16" between thru-bolts in cross pattern measurement, while 56 frame motors measure approximately 6 1/4" across with 5/16" thru-bolt heads and roughly 5 7/8" between thru-bolts measured in cross pattern.
