Description
Please Note: Only One Threaded Drain/Bleeder Port
The original Aqua-Flo XP2/XP2e wet end faceplate had 3 threaded drain/bleeder holes. Newer wet ends now come with only one threaded port. The other holes are molded into the plastic but do not have threads cut into them. If your installation needs more than one connection, you will need to tap the extra hole(s).
The Aqua-Flo XP2e pump wet end uses 1/4"-18 NPSM straight pipe threads for the drain plug opening. To add the threads, you will need a 1/4"-18 NPSM straight pipe thread tap. Carefully cut the threads by hand, keeping the tap straight and backing it out periodically to remove plastic shavings. Do not overtighten the drain plug when installing it.
Important: Use an NPSM straight-thread tap, not an NPT tapered-thread tap. The original drain plug uses an O-ring to create the seal.
This component is a full assembly 4HP Aqua-Flo 2" x 2" (measuring approximately 3" across threads) side discharge 48 frame wet end designed for XP2 pump systems. This assembly pairs with a 48 frame motor featuring approximately 14.0 Amps at high speed for 230V motor applications and is not compatible with 115v motors. Compatible motors include single speed or dual speed configurations. The discharge position can be adjusted 90 degrees by rotating the wet end assembly. Your complete assembly features: volute housing, seal assembly, impeller, wear ring, suction cover, suction cover o-ring, drain plug with o-ring, and mounting screws for suction cover.
Should you require a barb fitting for the wet end face where small diameter hoses attach, consider these options with or without sealant. We recommend using silicone for sealing as pipe tape performs poorly on these connections:
Barb Adapter, 3/8"b x 1/4"mpt, Pump Wet End Face fits Aqua-Flo & CMP
Barb Adapter, 3/8"b x 1/4"mpt, With Silicon Kit Pump Wet End Face fits Aqua-Flo & CMP
Important: Always select your HP rating based on motor amperage using the reference chart below. A 48 frame motor has a diameter of approximately 5 1/2" with 1/4" thru-bolt heads measuring roughly 5 3/16" between bolts in cross pattern, while 56 frame motors measure approximately 6 1/4" diameter with 5/16" thru-bolt heads measuring about 5 7/8" between thru-bolts in cross pattern.
