Complete Heaters

This part is a Heater Complete with the Sensor set and built in pressure switch an exact generic replacement for the original Watkins No Fault 6000 76227 heater... This is a generic replacement for the various versions of Watkins/Hot Spring/Tiger...

This part is a Heater Complete with the Sensor set and built in pressure switch an exact generic replacement for the original Watkins No Fault 4000 76228 heater...It will only work in countries that use a 60 Hz electric cycle. This is a generic...

This part is a Hydro Quip Versi-Heat remote heater replacement assembly. The metal tube measures 2" x 13" with a 5.5 kilowatt, 230v heater element inside. Some versions are 4.5kw but this one will work in place of that version without issue...

Popular 3.0 KW flow thru 15" heater with stud made by Balboa for European and 50 Hz systems that utilize the M7 heater design. Can be found in the Balboa VS, GS and BP systems. The assembly includes two new M7 sensors, tailpieces, union gaskets and a...

This part is a complete New Old Stock Heater that was used on some Icon or Jumpking Hot Tub and Others.. Stainless steel, 1-1/2" x 8-1/2", 1.0kW/115v replacement heater with ground lug, (2) 1-32 x 3/8" mounting studs, and split nuts. The element is...

This Part is a Surface Mount Style HI LIMIT: Single Pole Single Throw THERMAL FUSE Auto Reset (With NO CAPILLARY)This Hi Limit Surface mount surface mounts to the heater in a spot where it can read what the actual water temperature is flowing through the...

Stainless steel aftermarket replacement heater assembly that comes with (2) M7 Sensors and and the Split Nuts and Gaskets.. It is a direct fit replacement for Most Balboa Systems with M7 Sensors.   Heater Application Balboa Water Group Heater...

IN.XM-1-8-IR-PA-1 IN.XM-1-8-IR-PA-1IN.THERMIntelligent remote water heating system designed to be totally maintenance free.Separated from the pack, in.therm is an intelligent 4.0kW remote heater that integrates electronics in its power box. It includes a...

This item is a 1/8" MPT Brass Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole or...

Balboa Water GroupStainless steel replacement heater assembly, 4.0kW, 230v or 115v, the inside Diamater of the tube is 2" and the overall length of the tube is 15" not including the split nuts on each end. This comeplete heater includes M7 sensors,...

This part is a Jumper Strap Set of (2) Kit to connect the heater to the circuit board on Balboa LE and Value Systems. Measures 1-3/8" x 13/16" Circuit Board Application    Balboa Water GroupCircuit Board Model    LE, Value...

Balboa Water GroupStainless steel replacement complete heater assembly, 5.5kW, 230v or 115V.Thie heater measures 2" Inside Diameter of the tube and the length of the tube is 15". Includes M7 sensors, tailpieces, split-nuts and gaskets. Made for Balboa VS...