Hot Tub Parts by Tub Brand

This kit is a Set of (2) Air Bleeder barbed plugs,(2) 3/8" x 3/8" Barb couplers, (2) 4" long pieces of 3/8" Tubing and Silicon sealer usually used on a Dynasty Hot Tub with Waterway Hot Tub Pump Face to bleed the air off the pump while filling the tub up...

This kit is a Set of (2) Air Bleeder barbed plugs and Silicon sealer usually used on a Dynasty Hot Tub with Waterway Hot Tub Pump Face to bleed the air off the pump while filling the tub up. I have seen these fittings in many brands just compare the...

This 4 way Tee Kit is exclusively for HotSpring Hot Tubs made by Watkins and can be found under the name Hotspring, Solana, Tiger River, Caldera...  This is Kit consists of a 1" x 1" X 1" Tee with (2) barbed 1" Slip X 3/8" Barb Fittings that glue...

This part is a Black 3 1/4" Long Catalina Spa Diverter Handle Knob only. This Diverter Knob mounts on top of the Diverter Valve Stem Square that is about 7/16" Wide sticking through the diverter cap. The Diverter Valve that this part fits...

This part is a Electronic Pressure Switch for Watkins Solana, Caldera & Hot Spot, 2006 Thru Current that features 1/8th" MPT Standard Threads and 2 pin connectors for attaching the 2 wire 3 hole connector for a Watkins board. What goes...

This Parts is a NON-Standard 2" Heater or Pump Union O-Ring that measures 2 5/8" Center to Center. The O-Ring is 2 5/8" center to center and fits some unions but most unions are 2 1/2" center to center... Do not buy this O-Ring until you...

This part is a 3" wide Air Valve Handle in Gray that fits some Dynasty Air Valves.  This Diverter handle Slides on the Air Control Valve Stem that measures about 1/4" and is used to operate the Air Valves and is for Dynasty Spa only. The...

This part is a 3" wide Air Valve Handle in Black that fits some Dynasty Air Valves. This handle Says Trevi instead of Dynasty but they are exactly the same.. Dynasty sent us Trevi instead of Dynasty because they  This Diverter handle...

This part is a (1) Speed 56 Frame Complete Intertek Pump that fits Jacuzzi Premium brand Hot Tubs that have a band style base mount. These pumps usually have the part number WUA-400-I, and then 6500-352 or 6500-365 or 6500-367, or 6500-363 on the label...

This part is a Replacement Watkins Water Check Valve that is 3/4"Barb x 3/4" Barb..   This 3/4" water check valve is installed in the inlet side of the circulation pumps plumbing to prevent the back flow of water through the circulation pump once...

This part is an O-Ring that fits a Jacuzzi® J Pump Style Pump Union Only.. This O-Ring measures about 2-3/16" Inside Diameter and about 2 1/2" Outside Diameter.. Make sure you look at the pictures of a J Pump union provided in the picture section to...

This Pump is a Perfect Replacement option for a Watkins 39578-03 Pump it is a 2.5 Horse Power 12.0/4.4 Amp (2) Speed 56 Frame Complete Pump. It is about 7 1/4"" across the face of the pump, it measures about 7 3/8" from the bottom to the top of the...