Cal Spa Hot Tub Parts

This part is a Silver "S" Style 4 5/16" Long Diverter Handle and Graphite 3 11/16" Graphite Cap only. This Diverter Knob has a S Shaped Top and mounts on top of the Diverter Valve Stem Square that is about 7/16" Wide sticking through the...

This part is a "S" Style 4 5/16" Silver Spa Diverter Handle Knob only. This Diverter Knob has a S Shaped Top and mounts on top of the Diverter Valve Stem Square that is about 7/16" Wide sticking through the diverter cap. The Diverter Valve...

  Filter, Cartridge, 30sqft, 1-1/4" Female SAE Thread, 4-3/4" Wide, 11-3/8" Tall Bottom Physical Dimension 1-1/4" Bottom Style Female SAE Thread Diameter 4-3/4" Length 11-3/8" Media Type 3oz Square Footage 30...

This part is a complete Heater, Flo Thru, Balboa M7, 800, 825, 15" x 2", 230v or 115v , 4.0kW, with Sensors..  This heater tube has a stud on the top and bottom make sure yours has them too.. This heater DOES include m7 sensors and split nuts, but...

This Part is a Retrofit Heater tube to replace the original Cal Spa, Emerald of Polynesian 15 3/4" x 1 1/2" Heater and tube.. includes Tube, Element, Split nuts and Gaskets along with the 1 1/2" to 2" conversion fittings. This generic hot tub heater is...

This Filter is 14-15/16" wide x 14 7/8" tall it has 2 1/8" holes on the top and bottom.   Application Fountain Valley Spas, Martec/Sonfarrel, Santana, Sonfarrel/Advantage Bottom Physical Dimension 2-1/8" Bottom Style Open Diameter...

This part is a PC Board, Balboa, CS6200, Cal Spa Board, 6200DV..   Circuit Board Application    Balboa Water GroupCircuit Board Model    VS501ZCircuit Board Type    New This circuit board also replaces...

This part is a Hot Tub Replacement Bottom Drain Inside Wall Fitting with a 3/4" slip fitting on each end which measures about 1" I.D.. This part is on the foam side of the tub and the Fitting screws into this fitting.. You have to stand the hot tub up...

This part is a Single of Jumper Wire that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board Relay Spade Connector.. Loop for the heater side to female spade.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board...

This kit is a Set Of (4) Bolts and Grommets For A Cal Spa Hot Tub Front Access Panel Door.  The Bolt is 2" In Length And The Grommet Has 3/4" Diameter.  

This part is a Cal Spa Safety Suction Tee Fitting that has a 2" Pump Union that would measure about 3" Inside Diameter X 2" Slip Fitting that is 2 3/8" Inside Diameter with a 1/8" MPT Tap on the top to receive a Safety Suction on Top.. Note: The Cal Spa...