Cal Spa Hot Tub Parts

This kit is a Set Of (4) Bolts and Grommets For A Cal Spa Hot Tub Front Access Panel Door.  The Bolt is 2" In Length And The Grommet Has 3/4" Diameter.  

This part is a Cal Spa Safety Suction Tee Fitting that has a 2" Pump Union that would measure about 3" Inside Diameter X 2" Slip Fitting that is 2 3/8" Inside Diameter with a 1/8" MPT Tap on the top to receive a Safety Suction on Top.. Note: The Cal Spa...

This part is a Pressure Switch Cable that is 7" long and Universal for use on most SSPA, MSPA, T-MSPA, and some Hydroquip boards..

This circulation pump is a 230V Replacement for a Power Right pump found in some Cal Spas.. This Pump is a 2" X 2" Wet End which measures about 3" edge to edge across the threads.. This pump is a 48 frame 230V Side Discharge wet end with a 2" suction...

This circulation pump is found from the factory in many hot tubs and will be an easy installation for people who are handy.   This pump is a 48 frame 115V or 230V Side Discharge wet end with a 1 1/2" suction side and 1 1/2" pressure side which...

This part is a Spa Diverter (3) Piece O-Ring Kit only. This Diverter O-Ring Kit Features (2) Small O-Rings that fit on the Stem sealing the inside of the cap and (1) Large O-Ring that seals the outside of the cap and it fits many different brands The...

This item is a (6) Way Barbed Coupling used to couple 3/4" main hoses and 3/8" ID hose together. 3/4 Inch Barb X 3/4 Inch Barb through and (3) tees Barb Coupling 3/8" barb and 3/8" barb... This part is used on pump bleeder systems many time where the...

You are Buying a Lo-Profile Drain Assembly, 3/4" Barb, Black, 1-15/16" Face Width Replacement Bottom Drain Fitting Kit found on many brands of Hot Tubs. Remove the cracked inside the floor top Fitting and replace with this one by simply adding silicon...

You are Buying a Silicone Kit & Lo-Profile Drain Assembly, 3/4" Barb, Black, 1-15/16" Face Width Replacement Bottom Drain Fitting Kit found on many brands of Hot Tubs. Remove the cracked inside the floor top Fitting and replace with this one by...

This part is a Set of Jumper Wires that would go from a standard heater element Electrode Tab to the board bolts.. These can be used on 4.0kw to 5.5kw elements.. Circuit Board Application    Balboa Water GroupManufacturers Part...

We no longer have the Tear Drop Style air control but we have the new style replacement here: Air Control Valve Cal Spa Swoosh Style 1" Spa Hot Tub This Part is a  Cal Spa 1" Spa Hot Tub Air Valve " Cap Only". The Valve Tear Drop Cap Width is approx...

You are buying a Cal Spa 7000 or 9000 Heater M7 foam type Sensor. This Sensor comes with the wire, Connector, and The foam sensor. It DOES NOT include the tube, the tube side mount or the pull ties. When this sensor is bad it will generally cause a SN...