Shop

As of 11/2024 Aqua-flo has started to send this pump with a capacitor bump in an odd spot that may affect your installation. In light of that we are now sending this pump assembly out as a separate 10.5 Amp motor and a genuine 2.5 HP XP2 wetend. You...

This part is a PVC Tee, 1"slip x 2"slip x 1"slip.. You can make your connection back to the small side using the below kit..  Connect kit for 1" Soft pipe Click Here.. 1" Connect Kit Jacuzzi J Pump Fittings found here: Jacuzzi® J Pump...

This part is a Complete VL-200 or Eco-200 topside that is used on some Balboa 4 button systems..  It features Jet, Temp, Light reading left to right.. It has an 8 pin Cat 5 Phone Style plug and a cord that is 72" long.. Topside...

This Filter Core and Standpipe with Valve is made specifically for Oval Shaped Filter Cartridge that is 6-1/4" Outside Diameter on the Widest Part of the Oval x 9-3/4" in Length.

This part is a Heater Assembly for a HydroQuip CS800 Control Pack.. 4.5kW, 230V, 2" x 15" Long..  CS800 heater, 4.5kW, 2.25”x15”, 304SS, PSI tap, cover plate and studs. Includes 2” ridged gaskets.   Heater Style - Flow-Thru ...

This 2.5HP Impeller fits a Jacuzzi Piranha 4 Stand Wet End Fixed Bracket Motor only and would be found on a motor that is about 11.0 Amps on a 230V motor..... It can be found under the Name Thera-Max or Thera-Flo on Sundance tubs and is also on Jacuzzi...

Note: When you order this pump you will receive the newest version of the pump which is a baseless 2.5 HP pump and you will receive the base as well.. This will be able to be installed in any position but you will have to install the base which may not...

Note: When you order this pump you will receive the newest 2.5 HP version of the pump which is a baseless and you will receive the base as well.. This will be able to be installed in any position but you will have to install the base which may not line...

This filter is 13 1/2" X 4 15/16" and has a female SAE Large Thick Thread that is 2" which would really measure about 2 1/4-2 3/8" ID. This filter is found in Dynasty Bahama Tubs and others. If you have the shorter version of this filter which is 9 1/4"...

This part is a complete Heater, Flo Thru, Balboa M7, 800, 825, 15" x 2", 230v or 115v , 4.0kW, with Sensors..  This heater tube has a stud on the top and bottom make sure yours has them too.. This heater DOES include m7 sensors and split nuts, but...

This part is aflow-thru style is used on the 2006-forward Solana TX (triangle spa), RX (round) & SX (square) as well as the 2006-forward Hot Spot models except the Sprint and Dash. 15” length 4.0kWgrounding and mounting studsTemp Sensor or High...

Heater, FloThru, Watkins TR, 15" x 2", 4.0kW, 230v, Generic Note: This heater does not have a Pressure Switch port or studs for the ground bar..   Housing Configuration    StraightHeater Length    15"Lead End Terminal...