Shop

This part is a LA Spa Hot Tub Gray Neck Pillow found on some 2003 and newer LA Spa Hot Tubs.   It is right at 12 " long Edge to Edge, 4 3/8" Wide on the edge top to bottom and it has 1 pins dead in the center in the top rear of the pillow....

This Wet End is a 2" x 2" 1.5HP 48 or 56 frame Ultimax Vico® that would normally be found an a 230V pump with 9.0 Amps High speed or 14.0 Amps at 115v..  This side discharge, 2" x 2" mbt which would measure about 3" edge to edge on the threads,...

This part is a (1) 1 1/2" Slip X 1" Slip Coupler PVC Plumbing Fitting. The Coupler receives a 1 1/2" fitting which measures 1 7/8" OD on one side and then receives a 1" fitting which measures 1 1/4" OD on the other side. ...

This is a 1" Slip x Spigot Plug which measures 1 5/16" OD on one end and 1 5/16" ID on the other side it can be used to plug off a 1" Slip port which measures 1 5/16" ID on a manifold or other fittings or Cap a 1" Slip fitting that would measure about 1...

This part is a Temperature and Hi-Limit Sensor that fits some ACC SmartTouch control systems there is one sensor bulb is 1/4" Diameter and it uses (2) 2-pin connectors.. Fits most ACC Smartouch and Epack control systems regardless of year.

This part is a Temperature and Hi-Limit Sensor that fits some ACC control systems the cable is 20" long and the sensor bulb is 1/4" Diameter and it uses a 2-pin connector.. Fits ACC Smartouch and Epack control systems regardless of year.

This part is a Used New Style 3 Lug Terminal Block found on many Balboa Brand Spa Hot Tub Boards. This terminal Block can get burned on one or two legs and if the soldered on finger terminals are good on the board you can replace this part and not buy a...

This Seal Kit with bearing is used ONLY in Watkins HotSpring Caldera Wet Ends where the motor has the Vendor code of 3536. This kit features the seal, (1) bearing and an install tool as well as silicone to install the seal with.. It is 1 39/64" Across...

This Seal Kit is used ONLY in Watkins Hot Spring Caldera Wet Ends where the motor has the Vendor code of 3536. This kit features the seal and an install tool as well as silicone to install the seal with.. It is 1 39/64" Across the back of the Spring...

This Seal Set is used ONLY in Watkins HotSpring Caldera Wet Ends where the motor has the Vendor code of 3536. It is 1 39/64" Across the back of the Spring Seal part that goes into the volute or wetend back and the Ceramic & Rubber part that goes...

This Kit Fits Watkins, Vendor #4081, Wavemaster Pumps found under the name Wavemaster 6000, 7000, 8000, 8200, 9000, 9200 numbers Features (2) Bearings & (1) Seal for 4081 Pumps on Hotspring Watkins Hot Tubs and (1) 1/2Oz Tube of The Professor's Silly...

This is a Set of (3) barb plugs used to plug off a 3/8" port on Air manifolds or Air Sides of Jet Bodies that are above the water line of the tub. We offer many different plugs based on the brand of manifold.