Shop

This Parts is a NON-Standard 2" Heater or Pump Union O-Ring that measures 2 5/8" Center to Center. The O-Ring is 2 5/8" center to center and fits some unions but most unions are 2 1/2" center to center... Do not buy this O-Ring until you...

This item is a 1/8" MPT Plastic Plug which can be used to block an 1/8" MPT (male Pipe Thread) hole normally found on a Heater Tube on Hot Tubs. This hole size is the same size as a Pressure Switch hole and would measure about 3/8" wide across the hole...

NOTE: This Part will Fit Sundance® or Jacuzzi® Tubs with a Guangdong LX Wet End if you replace the entire Wet End for internal parts of the wet end you already have click here Jacuzzi® & Sundance® LX...

This part is a 3" wide Air Valve Handle in Gray that fits some Dynasty Air Valves.  This Diverter handle Slides on the Air Control Valve Stem that measures about 1/4" and is used to operate the Air Valves and is for Dynasty Spa only. The...

This part is a 3" wide Air Valve Handle in Black that fits some Dynasty Air Valves. This handle Says Trevi instead of Dynasty but they are exactly the same.. Dynasty sent us Trevi instead of Dynasty because they  This Diverter handle...

This part is a Balboa E4 4 Button Overlay for a 6-3/8" x 2-1/4" Rectangle Topside.        The button configuration of Jet, Jet, Temp and Light left to right. Make sure your old topside does not have a raise area for...

This part is a Front and Back Volute for a Vico, Ultimax, 2" X 2", 48 or 56fr motor.. This part will fit both 48 and 56 frame motors and does not come with any other accessories like the seal, bolts or impeller.. For other parts click this link for this...

This part is a Long Diverter Valve Stem Gate with (2) Small and (1) Large O-Ring and Handle that only fits a Marquis Brand Hot Tub. This Diverter Valve Stem Gate slides down into the Diverter Body and requires a cap that are sold separately and is...

This part is a Volute O-Ring, 6" ID, 3/32" Thick, Vico Ultimax, 48 or 56 Frame...

This part is a Replacement Watkins Water Check Valve that is 3/4"Barb x 3/4" Barb..   This 3/4" water check valve is installed in the inlet side of the circulation pumps plumbing to prevent the back flow of water through the circulation pump once...

This Face Plate O-Ring Is 5 1/8" Inside Diameter and is 1/8" Thick. It is found on Aqua-Flo 1 1/2" x 1 1/2" (Which Measures 2 3/8" Outside of the threads on the Sunction and Pressure Side of the Wet End) These Wet Ends used the names Flo-Master,...

This part is an O-Ring that fits a Jacuzzi® J Pump Style Pump Union Only.. This O-Ring measures about 2-3/16" Inside Diameter and about 2 1/2" Outside Diameter.. Make sure you look at the pictures of a J Pump union provided in the picture section to...