Shop

Top Draw Air ControlPart only

This part is a Bleeder Barb that is 3/8" barb x 1/4" Threaded MPT fitting fits Wet End Face Bleeder Plug Holes to attach a Bleeder Line it fits Waterway Executive 48 & 56 Frame Parts & Wetends, Power-Right 9089X, 9094X,...

Harwil Q12DS Flow Switch 1/2" NPT2 amp pilot duty switches on at 10 gpm and switches off at 8 gpm. ABS body, stainless spring armKit includes one each 60-555-1225, 1/2" strain relief connector&one 1/2"fpt x 1/2"fpt coupling.Stationary arm measurements:2"...

"Magicmend" Pipe extenderSimply cut the bad fitting and remove it from the system. Glue the correct size Magicmend into place and replumb your new fitting

This part is a Pump Bleeder Barb with O-Ring that is found on some Aqua-Flo Xp2 and Xp2e wet ends but is used with an unusual bleeder line.. The line is 1/4" Inside Diameter not 3/8" Inside Diameter like most bleeder lines.. This part does come with the...

Pipe extenderSimply cut the bad fitting and remove it from the system. Glue the correct size Magicmend into place and replumb your new fitting

This part is a Filter, Cartridge, 10sqft, 4" Tall X 4-1/4" Wide, 1-15/16" Top Hole, 1-15/16" Bottom Hole... Diameter    4-1/4"Length    4"Top Style    OpenTop Physical Dimension  ...

This fitting is a 90 degree glue in style spigot x barb. The Spigot side will glue into a 1" fitting that measures about 1 1/4" Inside Diameter and the barb accepts a 3/4" inside diameter hose usually a clear hose. These are usually used on water control...