Shop

This 115V Laing E-10 pump with a 3/4" Barb Suction and Pressure Side which measures about 3/4" Outside Diameter and the hose is 3/4" Inside Diameter  is compact and lightweight, less than 5 lbs. It is whisper quiet, highly efficient and designed...

Start Capacitor1-7/16"dia x 2-3/4"hgt

This is a 1.5HP Impeller for an Aqua-Flo 48 Frame Side or Center Discharge FMHP, FMCP, FMVP, and TMCP Series Wet End 1.5HP Motor that has about 9.0 Amps on High Speed at 230V and 14.0 Amps at 115V. This Impeller fits between the Face and the Volute of...

This circulation pump is found from the factory in many hot tubs and will be an easy installation for people who are handy.   This pump is a 48 frame 230V Side Discharge wet end with a 1 1/2" suction side and 1 1/2" pressure side which measures...

You are Buying a Gray Notched 3 3/4" Spa Diverter Cap only. This is a NON  Buttress Cap if your cap has the word Buttress stamped in it look in our store for a Buttress cap. This Diverter Cap mounts on top of the Diverter Valve with...

This Part is a Single Jumper Strap for a Balboa, EL, VS, GL or GS, Heater to Board connection.. This part is made from Copper.. Measures 2" x 13/16" Circuit Board Application    Balboa Water GroupCircuit Board Model    EL,...

As of 11/2024 Aqua-flo has started to send this pump with a capacitor bump in an odd spot that may affect your installation, see pic 2. In light of that we are now sending this pump assembly out as a separate 10.5 Amp motor and a genuine 2.5 HP XP2...

This is a 2.5HP Impeller with a 2 1/8" Eye width and 5/16" Vane width and 4" OD for anAqua-Flo 48 or 56 Frame Wet End 2.5HP Motor that is about 11.0 Amps on High Speed. This Impeller fits between the Face and the Volute of an Aqua-Flo XP2 or FMXP2 Wet...

You are buying a (1) 90° 1 1/2" Slip X 1 1/2"Slip PVC Plumbing Fitting. The 90° ELL receives a 1 1/2" fitting on each side which would measure 1 7/8" Inside Diameter. Any 2"  fitting (which measures 1 7/8" outside diameter) will glue into...