Shop

This part is a Pressure Switch 4015, 25A, Tecmark, 1/8"mpt, SPDT, Plastic Manufacturer Tridelta/Tecmark Switch Type Pressure Pressure Switch Rating 1 to 11 PSI Rating 1 to 11 psi Pressure Switch Amperage 25A Thread/Pan...

Sweep ELLSAll fittings meet or exceed A.S.T.M. Schedule 40 standards. White pvc1-1/2"spg x 1-1/2"s

This part is a Basket for a Filter housing mounted in a hot tub shell, It is made by Rainbow/Pentair and is Gray in color..  There are tabs on each side at the top that hold a weir in place and they will break off allowing the weir to float out...

Reducer, 2" Spigot or Street x 1" Slip This part is used by gluing it into a 2" fitting which would measure about 2 3/8" Inside Diameter and then you could glue 1" Pipe or fitting inside of the 1" Slip fitting which would measure about 1 1/4" Outside...

This part is an Air Switch, Tecmark, TBS 339, SPNO, 25 Amp, Threaded, Latching.. Wire connects are 5/16" male quick connect Spade Type tabs and required panel hole is 5/8"..25 AmpSingle Pole Normally OpenLatching Style Switch Note: The Nut Style can vary...

This part is a 2" Slip X Dead End X (4) 3/4" Barbs manifold and a single barb plug in case you only need 5 barbs instead of 6. The Manifold receives a 2" pipe on one side and then is a Dead End on the other...

3/4" Water X 1/2" Air This complete Jacuzzi BMH jet includes a plumbing kit. The plumbing kit includes: 1" x 3/4" 90° reducer 1-1/2" x 1-1/2" x 3/4" tee 3/4" 90° 3/4" tee 3/4" street 90° 3/4" 45° 1/2" street 90° 1/2" coupling 1/2"...

This Manifold is  1" input which measures 1 1/4" Inside Diameter x (4) 1/2" outputs that measure 3/4" Inside Diameter.  Barb/Port Size 1/2" Barb Port Type Slip (s) Number of Ports 4 Manifold Fitting Type Transition Manifold Plumbing...

This part is a 5.5KW Sundance Sentry 850 / 750 Smart Heater Complete Assembly includes the Body, Element, Case and Manual Bimetallic Hi Limit with wires. This unit features a BiMetallic Backup high limit and the wires that tie to the board and is exactly...

This part is a face plate drain plug for Aqua-Flo pumps.. It does not come with an O-Ring you will find the link to that below.. Aqua-Flo Pump, Drain Plug, O-Ring Xp2, Xp2e, XP3, 7/16" ID, 3/32"  

This part is a 4 HP 56 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and the Wear Ring. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will be 3...