Shop

This part is aSpa Diverter Valve Internal Stem only. This Diverter fits many different brands but it looks similar to some brands that it will not fit so be careful in your choice, check the measurements against your old stem valve and watch the...

Specifically designed for Residential, Commercial and Industrial applications, the Magic MIP Ball Valves are equipped with EPDM Seats and O-Rings, providing smooth operation and excellent chemical resistance. All Valves comply with ASTM 2467 Standards...

This part is a Gray Water Control Valve normally used for a Waterfall or Neck Jet Control, it is a full On/Off Valve made by Waterway, the plumbing connects are 1" Slip x 1" Slip Single Port.. To connect the valve to 1" plumbing simply glue inside of...

 This filter is 13 1/2" X 4 15/16" and has a female SAE Large Thick Thread that is 2" which would really measure about 2 1/4-2 3/8" ID. This filter is found in Four Winds Tubs, Barefoot and others. Note: The version of this filter can vary but they...

Polyjet Wrench/PlugCombo Tool

This part is a Pressure Switch 4015, 25A, Tecmark, 1/8"mpt, SPDT, Plastic Manufacturer Tridelta/Tecmark Switch Type Pressure Pressure Switch Rating 1 to 11 PSI Rating 1 to 11 psi Pressure Switch Amperage 25A Thread/Pan...

Sweep ELLSAll fittings meet or exceed A.S.T.M. Schedule 40 standards. White pvc1-1/2"spg x 1-1/2"s

This Part is a Wall Fitting Gasket used on Pentair Luxury Micro Jet Body Flanges between the flange and the color side of the hot tub shell.. You use silicon to seal the underside of the shell on the jet body side.. Note: Do not get the silicon on the...

This part is a Basket for a Filter housing mounted in a hot tub shell, It is made by Rainbow/Pentair and is Gray in color..  There are tabs on each side at the top that hold a weir in place and they will break off allowing the weir to float out...

Poly Jet Wall Fitting Gasket

Reducer, 2" Spigot or Street x 1" Slip This part is used by gluing it into a 2" fitting which would measure about 2 3/8" Inside Diameter and then you could glue 1" Pipe or fitting inside of the 1" Slip fitting which would measure about 1 1/4" Outside...