Shop

You are buying a 2" Slip X 2" Slip X (4) 3/4" Ports Manifold open style. This part used in tubs where 3/4" softpipe which measures 1" OD glues inside the ports and goes to the back of each jet in the tub and is plumbed into 2" Pipe which measures 2 3/8"...

You are buying on a 25Amp Pressure Switch Universal Kit that features 1/8th" MPT Standard Threads and 2 Spade connectors for attaching the 2 wire connections and Some Brass Adapters to change the 1/8"mpt connector over to an 1/8" Barb or to a compression...

You are buying a (1) 90¡ 1 1/2" Street X 1 1/2"Slip PVC Plumbing Fitting. The 90¡ ELL receives a 1 1/2" fitting on one side which would measure 1 7/8" OD and then slips into a 1 1/2" fitting on the other side that would measure 1 7/8" ID. It will Glue...

This fitting is a PVC Tee that features (3) 3/8" Barbs that receives a 3/8" ID pipe on all three sides. Note: Colors can vary.. The Smooth Style and Barbed Style both work well with vinyl tubing as in most cases 3/8" tubing in hot tubs is suction not...

Aqua-Flo Xp2 Flo-Master 48Frame Pump Face O-Ring Only fits around the Face of a Xp Pump Face exclusively for An Aqua-Flo Xp 48 frame pump which has 2" inlet and outlet which measures about 3" across the threads... If you have a Xp2 56frame 6.1" or 6'3"...

This part is a Balboa Heater M7 Sensor. This Sensor comes with the wire, Connector, and The Screw down cap. It DOES NOT include the tube and the tube side mount. You will normally not need the sensor mount you would reuse it so there is no reason to have...

You are buying a (1) 1 1/2" Slip X 1 1/2"Slip Coupler PVC Plumbing Fitting. The Coupler receives a 1 1/2" fitting which measures 1 7/8" OD on one side and then receives a 1 1/2" fitting which measures 1 7/8" OD on the other side. The inside...

Inside Pipe Repair Glues Inside 2" Pipe and allows a 2" Slip to be glued over or a 1 1/2" Slip to be glued inside. Magic Mend Simply cut the bad fitting off of 2" hard pipe and remove it from the system. Glue the 2" Spigot Street end of the Magicmend...

Barb Adapter 3/4" Barb x 1/2" Spigot , The Glue Side glues inside a 1/2" Fitting which would measure 3/4" and a 3/4" ID tube would be glued over the barb.

This Kit is an 4HP Impeller for an Executive 48 Frame Wet End up to 4HP Motor and a 56 Frame Wet End 4HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you replace...

Inside Pipe Repair Glues Inside 1 1/2" Pipe on both ends. Magic Mend Simply cut the bad fitting off of 1 1/2" hard pipe and remove it from the system. Glue the 1 1/2" size Magic Mend in between two pieces of 1 1/2" ID pipe to mend pipe back together PVC...

This is a plug used to plug off a 3/4" port on Waterway manifolds only to make for example a (6) port manifold a 5 by plugging one.