Shop

You are buying a (1) 1 1/2" Slip X 1 1/2"Slip Coupler PVC Plumbing Fitting. The Coupler receives a 1 1/2" fitting which measures 1 7/8" OD on one side and then receives a 1 1/2" fitting which measures 1 7/8" OD on the other side. The inside...

Inside Pipe Repair Glues Inside 2" Pipe and allows a 2" Slip to be glued over or a 1 1/2" Slip to be glued inside. Magic Mend Simply cut the bad fitting off of 2" hard pipe and remove it from the system. Glue the 2" Spigot Street end of the Magicmend...

Barb Adapter 3/4" Barb x 1/2" Spigot , The Glue Side glues inside a 1/2" Fitting which would measure 3/4" and a 3/4" ID tube would be glued over the barb.

This Kit is an 4HP Impeller for an Executive 48 Frame Wet End up to 4HP Motor and a 56 Frame Wet End 4HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you replace...

Inside Pipe Repair Glues Inside 1 1/2" Pipe on both ends. Magic Mend Simply cut the bad fitting off of 1 1/2" hard pipe and remove it from the system. Glue the 1 1/2" size Magic Mend in between two pieces of 1 1/2" ID pipe to mend pipe back together PVC...

This is a plug used to plug off a 3/4" port on Waterway manifolds only to make for example a (6) port manifold a 5 by plugging one.

This part is a 35 Square Foot Filter Cartridge that is 4-15/16" Outside Diameter x 9-1/4" in Length. It has a hole in the top and the bottom that are 2 1/8". This Filter (The Most Popular) is found many Spa Hot Tub Brands Aber , After Hours , Belize ,...

This part is a 25Amp Pressure Switch that features 1/8th" MPT Standard Threads and 2 Spade connectors for attaching the 2 wire connections. Watch the Video for How To Information on Pressure Switches. This Switch will fit Balboa,...

This part is a 2 1/2" Therm Style Pump or Heater Union Gasket Only for use with a 2 1/2" Heater or Pump Union. If your heater or Pump is 2 1/2" this part could be correct we offer (2) different sizes of 2 1/2" gaskets so you need to verify your...

You are buying a 1 1/2" Heater Split Nut Only which includes the split nut and (2) Screws for use with a 1 1/2" Heater Union that would measure about 2 3/8" OD... The Heater Flange Split Nut mounts to the heater tube using 2 screws to hold it in...

This part is a Standard Balboa Heater M7 Sensor with a 24" wire. This Sensor comes with the wire, Connector, and The Screw down cap. It DOES NOT include the tube and the tube side mount. You will normally not need the sensor mount you would reuse it so...

You are purchasing a SC-20 Buss or Cooper Bussman Fuse that is 1 1/4" Long X 3/8" wide found on many Balboa , Gecko, Hydroquip , ACC, Nuwave , Len Gordon , Spa Builders and more Brand Spa Hot Tub Boards and control packs. This Fuse can also be found...