Shop

Ozone Check Valve 1/4" B x 1/4" B Prozone Viton, If this valve is bad you will get water in the Ozonator and possibly voltage in the water if your GFCI is not wired correctly or a breaker trip if it is wired correctly

This is a plug used to plug off a 3/4" port on manifolds we offer many different plugs based on the brand of manifold.

This part is a 1 1/2" Slip X 1 1/2" Pump Union with Gasket or Oring that matches Union. The Union receives a 1 1/2" pipe or fitting on one side and then Screws to a 1 1/2" Wet end(Pump) Threaded Part on the...

This O-Ring is 5 1/8" Inside Diameter and 3/16" wide and is used in many applications for Wet Ends between the Face and Volute or under a Trap Lid brands include Hayward, PacFab, Pentair, Sta-Rite in these series Dura-Jet DJ Series Wet End Faces, Dynamo,...

This 5 7/8" O-Ring is used in many different applications such as filter housings with screw on housing bosides as well as some pool applications. The inside diameter is 5 7/8 and it is 3/16" wide.  This o-ring fits this Pressure filter...

This part is a 2 1/2" Pump Union Gasket Only for use with a 2 1/2" Pump Union that would measure about 3 5/8" Inside Threads. This gasket measures 3 1/4" O.D. x 2 3/8" I.D. and the lip is 2 7/8" center to center. This version is the 4th most...

This part is a (1) 2" Slip X 2"Slip Coupler PVC Plumbing Fitting. The Coupler receives a 2" fitting which measures 2 3/8" OD on one side and then receives a 2" fitting which measures 2 3/8" OD on the other side. The inside diameter of...

This part is (1) 45 Degree 2" Street X 2"Slip PVC Plumbing Fitting. The Union glues into a 2" fitting on one side and then receives the fitting on the other side. It will Glue into any 2" fitting to make a tight plumbing application. The inside diameter...

This part is a 2" Street X 2" Slip X (6) 3/4" Barbs manifold and a single barb plug in case you only need 5 barbs instead of 6. The Manifold receives a 2" pipe on the slip side which would measure about 2 3/8" Outside...

You are buying a Air Bleeder barbed plug usually used on Hot Tub Pump Faces to bleed the air off the pump while filling the tub up. I have seen these fittings in many brands of Hot Tubs just compare the pictures and measurements with your current fitting...

This Upgraded Titanium Heater Element is considered the Best of the 3 styles of heater Incoloy being Good, Teflon Coated being Better and Titanium being Best. This element suitable for use in heater assemblies that are used with Salt systems and it also...

You are buying a 4.0KW Heater element that features the bend in the back of the element needed to fit the Balboa M-7 heater tubes. This also fits Gecko, ACC, and most other standard Hot Tub Heater Tubes. The list on this manifold is $69.50...