Shop

You are buying a PS-1000 Seal only. This Seal is used Primarily in Waterway Brand Wet Ends. It is 1 3/8" Across the back of the Spring Seal part that goes into the volute or wetend back and the Ceramic & Rubber part that goes into the...

This part is a 2" Pump Union Split Nut Repair Kit which includes the split nut and (2) Screws for use with a 2" Pump Union. The Pump Union Split Nut that measures about 3" on the Inside of the Threaded Side and mounts to the existing Pump Union Body...

You are buying a 5.5KW Incoloy Heater Element for 230V or 115V Applications that features the bend in the back of the element needed to fit the Balboa M-7 heater tubes. This also fits Gecko, ACC, and most other standard Hot Tub Heater Tubes...

This part is a 3/4" Barb x 3/4" Barbed Coupling used to couple 3/4" ID Tubing together. 3/4 Inch Barb X 3/4 Inch Barb..  Other Parts Normally used with this part: Tubing 3/4" Inside Diameter 1" OD (1) Foot Used on Water Manifolds and More (2) Feet...

You are buying a Kit that Features (1) PS-200 Seal for Aqua-Flo Pumps. This Seal is Used Primarily in Aqua-Flo Wetends but is found in some other brands like a Waterway "Viper*" Wet End. Pump Seal Assy 5/8"Shaft, 1.218"Seal O.D., 1.250"Seal O.D. The...

Flat Gasket for 1-1/2" Union Pump or Heater, 2-5/16" OD, 1-7/16" , This gasket can be used in conjunction with an o-ring when you need extra room for a tighter seal.

This part is a Flat Gasket for 2" Union, 2-15/16" OD, 2-1/8" ID no Lip, This gasket is used in many applications and can be using in combination with an o-ring if you need extra thickness to make a good seal. Heater Union Part Type  ...

This part is a Standard 2" Heater or Pump Union Gasket with a 2 1/2" Lip Center to Center. The gasket is 2 7/8" across on the outside the inside diameter is about 2 3/16" and the lip that fits into the union is 2 1/2" center to...

This Part is an 48 Frame 3/4HP TMCP Aqua-Flo Wet End for a Garden Tub Bath Pump that has a voltage of 115V and an Amperage of about 10-11 Amps..  Note: The outside measurement of the threads on this wet end are about 2 3/8" meaning the inside...

This item is a Modified 2 1/2" Heater Union Tailpiece with a Pressure Switch Tap and Gasket that is used on may heater tubs that measure about 3" inside diameter of the tube.. It also has a 90 degree 1" Barb fitting.. This Union has had a Pressure Switch...

You are buying on a 2 1/2" Heater Split Nut with a Gasket which measures 3 9/16" ID. The Heater Flange Split Nut mounts to the heater tube using 2 screws to hold it in place and screws onto the heater threaded union with a gasket between the union and...

This part is a set of (2) Bearings that fit most motors that are used in hot tubs, this bearing is 17MM ID. Some of the motors this fits are A.O.Smith/Regal Beloit, Century/Regal Beloit, Franklin Electric, General Electric NOTE: Installing bearings...