Shop

This Listing is for a Waterway Executive 56fr 2 Speed 230V 2 HP 2 1/2" X 2" Pump. Your sticker may say 3HP but based on the chart it is really a 2HP at 10 Amps. This Pump is a 2 1/2" x 2" which is only found in a few hot tubs like Catalina, Some Leisure...

Waterway Hi-Flo Wet EndSide discharge, 2"mbt suction/discharge, 48 frame wet end for the Waterway Hi-Flo pump. This wet end is used with a 1.5hp, 48 frame, thru-bolt style motor. The motor used may be either a single or dual speed. The wet end may be...

The "Smart" Check is equipped with a 1/2Ó lb spring-loaded gate mechanism, allowing the valve to be installed in virtually any orientation.   Check Valve Application Water Plumbing Size 1-1/2" Plumbing Type Slip (s) Check Valve Type...

This cord is used to convert a Blower with a 3 Wire Female Amp Plug over to a J&J style 3 wire connector plug for use on controls that require a J&J Plug.. Male End Plug Style   Molded, Mini Lit Female End Plug Style AMP, 4 Pin Wire...

1 Speed Rotating Switch

This Pump is a 48Frame 2115V 2 Speed with a 1.0 HP Wet End that features a 1 1/2" x 1 1/2" Center Discharge inlet and outlet Wet End that measures about 3" across the threads...  High speed Amperage is 10.3A and low speed is 3.8 Amps.. Complete...

You are buying a 4 HP 48 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and the Wear Ring. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will be 3...

This part is the Control Box Side Female AMP Connector that houses (3) Female Pins.. The Pins are not included..   Terminal Type AMP Terminal Style AMP Cap Housing Female Number of Connections 3 Terminal Amperage 20A The other parts...

This part is a Complete 1HP Aqua-Flo 2" x 2" ( Which measures about 3" Across the Threads) Side discharge 48 frame wet end for XP2 pumps. This wet end is used with a 48 frame motor that would have about 8.0 Amps on High Speed on a 230V motor or 12.0 Amps...