Pumps and Related Parts

This part is a PUMP MOUNTING BRACKET FOR: 48 FRAME NPMM Pump, Jacuzzi / Sundance, Baseless, TheraFlo, . Note: This will Only Work in Jacuzzi and Sundance Hot Tubs that have a removable base and also use to rotate mote at a 45 degree angle.  DO NOT...

OEM TheraFlo 1.5 HP, 2 speed pump assembly with baseless motor. Used in entry level Jacuzzi, Sweetwater and Sundance spas that utilize the unique pump bracket that straps around the motor. This pump assembly can be mounted and adjusted to accommodate...

This pump is a rated 5HP Viper 2 1/2" x 2 1/2" 56 Frame Spa Pump... The measurement from the edge of the thread to the edge of the thread on the Suction and Pressure side is 3 11/16"..  It is an unusual pump not found in most hot tubs.. It is...

This pump is a rated 4HP Viper 2 1/2" x 2 1/2" 56 Frame Spa Pump... The measurement from the edge of the thread to the edge of the thread on the Suction and Pressure side is 3 11/16"..  It is an unusual pump not found in most hot tubs.. It is...

This 5 3/4" Inside Diameter O-Ring fits around the face of a Waterway HI-Flo 48 Frame Wet End all Horsepowers and fitting sizes... This is (1) O-Ring ONLY!! As you can see below it fits other pumps and filter housings as well.. Part...

This part is a Stationary Switch, Century, Wishbone, 2 Speed, Pump, Motor, Switch.. The thing that happens to this switch is one of the phenolic pads on the edge of the wishbone falls off and the motor will not start in low speed because the wishbone...

This 230V Laing E-10 pump with internal Flow Switch.  Has a 1" Barb Suction and Pressure Side hich measures about 1" Outside Diameter and the hose is 1" Inside Diamater  is compact and lightweight, less than 5 lbs. It is whisper quiet, highly...

This O-Ring fits most pump Drain Plugs..  

This part is a 5 HP 56 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and Wear Ring.  The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will...

You are buying a 2 HP 56 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and Wear Ring. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will be 3...

You are buying a 4 HP 56 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face, Wear Ring, Bleeder Barb and Silicon.  The Bleeder Barb Replaces one of the plugs and is used to reconnect your previous 3/8"...

You are buying a 3 HP 56 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face, Wear Ring, Bleeder Barb and Silicon.              The Bleeder Barb Replaces one of the...