Sensors Circuit Board

HydroQuip Temperature Sensor, 72" with 1/4" diameter temp probe. Common to find these used on the Versi Heaters and 9700 series spa controls. Please Note: This 2 wire sensor will replace all previous 3 wire styles. For SSPA, USPA, MP, 6200, 9200, 6500,...

In this video The Spa Guy tells you the basics about diagnosing and replacing a M7 sensor on a Balboa Board.  Click this link for the m7 sensors on this site: M7 Sensor #sparepair #hottubrepair #spaguy #thespaguy Save Save Save Save Save Save Save...

This Part is a Surface Mount Style HI LIMIT: Single Pole Single Throw THERMAL FUSE Auto Reset (With NO CAPILLARY)This Hi Limit Surface mount surface mounts to the heater in a spot where it can read what the actual water temperature is flowing through the...

Temperature Sensor This sensor is used primarily in the Jacuzzi J-Series, however it was also used in the Sundance 1998+ 701, 724, 2005 780/850E, 2006+ 780/680 systems as well. This is the curly finger style that usually found in a 4 wire connector... If...

This part is a Balboa Heater Tube M7 Sensor Mount only. This Mount is screwed into the heater tube and the M7 sensor is slid down in the mount and screwed onto the mount. It DOES NOT include the tube or the sensor they are included in the pictures to...

Temperature sensor mount for older Sundance 601-605 and 624 systems. Can also be used for other sensors with a 3/8" diameter. The male thread on this sensor mount is 1/2" Mpt   Heater Part Type Strain Relief Manufacturer Heyco Defining...

Temp/Hi Limit Sensor Assembly

This part is a Temperature Sensor For 6200, 6220, 6230, 6330, 7500, 9700 Control systems. Used On: SSPA-SC-CF/MSPA-MP LINE Replacement Option For:AI #5-60-6021 / MFG #9920-400723AI #5-60-6066 / MFG #9920-400262 (3-Wire) Sensor Application Spa...

Temperature Sensor This sensor is used with Some Jacuzzi Premium Hot Tubs and the following Sundance systems: 1992 Suncoast, 1996-98 Suntub, 1997-2005 400, 600, 600-S, 750, 800, 1997 850, and 2005+ 880 series Usually this Temp Sensor is bad when it gives...

This is a Balboa Temperature & Hi Limit Combination. This is a standard part and fits most Balboa 4 pin applications that are no M-7. It features a 4 pin connector will Curley Finger style ends and the Temperature Sensor Cable is 96" long and the Hi...

This part is a Balboa Heater M7 Sensor. This Sensor comes with the wire, Connector, and The Screw down cap. It DOES NOT include the tube and the tube side mount. You will normally not need the sensor mount you would reuse it so there is no reason to have...