Shop

This pump is a 56 frame Motor with a Vico Side Discharge Wet End with 2" Suction and Pressure Threaded fitting that measure about 3" from edge to edge on the threads. This is a 2 Speed pump and the Amerage is 8.0 on high speed and 3.0 on low speed which...

The Waterway center discharge wet end has been discontinued and replaced with the E-Series Center Discharge wet end by the manufacturer. Please be sure which wet end you have as the parts are not interchangeable. The easiest way to identify which wet end...

This part is a 5 Position 50 Amp Terminal Block found in Balboa Lite Leader Packs and some others..  Terminal Type    Terminal BlockTerminal Style    Terminal Block/StripNumber of Connections    5Terminal...

Waterway 90 degree elbow with built in 5/16" thermowell for temp or hi-limit capillaries, sensors and probes. This elbow has 1-1/2" slip fittings that will measure 1-7/8" on the inside or each side. PVC Pipe Fitting Type Ell, 90 deg w/t-well Heater...

This part is a 2HP Sta-Rite DJ Dura-Jet Pump Impeller.. This impeller will usually have the number 17400-0122 cast into the back and will measure about 3 3/4" wide with an eye width of 1 1 3/4" and a vane width of 1/2".. This can be found on motors with...

This part is a Complete Flo-Master FMCP 1.5HP Aqua-Flo 1-1/2" x 1-1/2" ( Which measures about 2 3/8" Across the Threads) Center discharge 48 frame wet end for 48FR pumps. This wet end is used with a 48 frame motor that would have about 9.0 Amps on High...

Start Capacitor1-7/16"dia x 2-3/4"hgt

This Pump is a 48Frame 230V 2 Speed with a 2.0 HP Wet End that features a 1 1/2" x 1 1/2" inlet and outlet Wet End that measures about 2 5/16"" across the threads...  High speed Amperage is 8.5 and low speed is 2.8 Amps..   Complete Pump...

You are buying a 3 HP 56 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and the Wear Ring. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will be 3...