Shop

You are buying a 4.0KW Chemical Resistant DuPont Teflon® Coated Flow Thru Heater Element for 230V or 115V Applications that features the bend in the back of the element needed to fit the Balboa M-7 heater tubes. This also fits Gecko, ACC, and most...

This Listing is for a Waterway Executive 56fr 2 Speed 230V 3 HP 2 1/2" X 2" Pump. Your sticker may say 4HP but based on the chart it is really a 3HP at 12 Amps. This unit features a 2" X 2" Executive Wet End that can be moved from the 12 O'clock...

"Magicmend" Insider Connector - Fits inside of 1" pipe which would meausre 1" Inside Diameter and 1 1/4" Outside Diameter.  Why use an additional fitting when you can use a MagicMend® Insider Connector? The MagicMend® Insider Connector will...

Waterway PlasticButton style single hole air injector with 5/16" barb fitting. 3/8" hole required for installation   Hole Size 3/8" Face Diameter 3/4" Manufacturer Waterway First Plumbing Connection Size 1/4" First Plumbing Connection...

This item is a Replacement Diverter Cap for a 1" Waterfall or Neck Jet Control.. The inside thread measurement is about 1 5/8" and the center hole is about 3/4".. It uses (2) Small o-rings and one O-Ring Gasket that measures about 1 1/2" center to center...

Waterway PlasticSide output LO-PRO injector. 3/4" hole required for installation

This part is a 6 1/4" Top Load Style filter Lid NUT that is found on top off Waterway Pressurized filter housings.. This Nut has a slide lock that locks the nut into place so it can't vibrate loose.. .. The Additional Parts for this lid can be...

This part is aSpa Diverter Valve Internal Stem only. This Diverter fits many different brands but it looks similar to some brands that it will not fit so be careful in your choice, check the measurements against your old stem valve and watch the...