Plumbing and Related Parts

This part is a Barb Adapter 3/4" Barb x 1" Street or 3/4" Inside Slip.

Inside Pipe Repair Glues Inside 1 1/2" Pipe & into 1 1/2"spg Fittings Magic Mend Simply cut the bad fitting off of 1 1/2" hard pipe and remove it from the system. Glue the 1 1/2" size Magicmend into the pipe and replumb your new fitting

This part is a Barb Adapter 3/4" Barb x 3/4" Street or 1/2" Inside Slip.. The means a 3/4" Inside Diameter tube would glue over the barb side while a 1/2" pipe which is 3/4" Outside Diameter would glue inside or a 3/4" Slip fitting that measures 1"...

Inside Pipe Repair Glues Inside 2" Pipe & into 2"spg Fittings Magic Mend Simply cut the bad fitting off of 2" hard pipe and remove it from the system. Glue the 2" size Magicmend into the pipe and replumb your new fitting

This item is a 1/2" Slip x 1/2" Slip pvc coupler the inside diameter of the coupler is 3/4", This is a chart for the outside of your plumbing pipes so you can figure out what size parts to order. Note: The actual size a part is called is not the actual...

This part is a 1 1/2" Slip X 1 1/2" Pump Union with Gasket or Oring that matches Union. The Union receives a 1 1/2" pipe or fitting on one side and then Screws to a 1 1/2" Wet end(Pump) Threaded Part on the...

This part is a (1) 2" Slip X 2"Slip Coupler PVC Plumbing Fitting. The Coupler receives a 2" fitting which measures 2 3/8" OD on one side and then receives a 2" fitting which measures 2 3/8" OD on the other side. The inside diameter of...

This part is (1) 45 Degree 2" Street X 2"Slip PVC Plumbing Fitting. The Union glues into a 2" fitting on one side and then receives the fitting on the other side. It will Glue into any 2" fitting to make a tight plumbing application. The inside diameter...

You are buying a Air Bleeder barbed plug usually used on Hot Tub Pump Faces to bleed the air off the pump while filling the tub up. I have seen these fittings in many brands of Hot Tubs just compare the pictures and measurements with your current fitting...

This part is a 2" Street X 2" Slip X (4) 3/4" Barbs manifold and a single barb plug in case you only need 3 barbs instead of 4. The Manifold receives a 2" pipe on the slip side which would measure about 2 3/8" outside...

This item is a Barbed Coupling used to couple 3/8" ID hose together. 3/8 Inch Barb X 3/8 Inch Barb, Barb Coupling, 3/8"b x 3/8"b

This part is a 3/4" Barb x 3/4" Barbed Coupling used to couple 3/4" ID Tubing together. 3/4 Inch Barb X 3/4 Inch Barb..  Other Parts Normally used with this part: Tubing 3/4" Inside Diameter 1" OD (1) Foot Used on Water Manifolds and More (2) Feet...