Pumps and Related Parts

The Waterway Executive 48 pump is thermally protected to extend the life expectancy of the motor with a highly versatile wet end.Spa Pump Features: Executive wet end designed specifically for 48-frame motors Large 6-1/2" diameter wet end for higher head...

This part is a Complete 1.5HP Aqua-Flo 2" x 2" ( Which measures about 3" Across the Threads) Side discharge 48 frame wet end for XP2 pumps. This wet end is used with a 48 frame motor that would have about 9.0 Amps on High Speed on a 230V motor or 13.0...

You are buying a 4 HP 56 Frame Waterway Executive 2 1/2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and the Wear Ring. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will...

Vico/Balboa Ultima/Ultra Flo Pump ImpellerClosed face impeller made for the Ultima and Ultra Flo spa pumps by Vico/Balboa. Rated at 1.5hp,which is between 8 and 9 Amps.. it is used in an Ultima and/or Ultra Flo pump wet end, and must be installed on a 1...

The Waterway Executive 48 pump is thermally protected to extend the life expectancy of the motor with a highly versatile wet end.Spa Pump Features: Executive wet end designed specifically for 48-frame motors Large 6-1/2" diameter wet end for higher head...

This part is No Longer Available if you need a face you will have to choose a complete wet end..  Note: Due to a design change in the current XP2/XP2e pump wet ends, face plate or volute replacement is not suggested. Instead, replace the wet end to...

This part is a 100 ft roll of Air Tubing 1/8" Inside Diameter is used with Air Buttons, Air Button Style Topsides and Air Switch Applications and between Garden Tub Pumps and Air Button Switches... Air Tubing Inside Diameter 1/8" Tubing Type Air ...

This part is an Aqua-Flo XP2 Impeller for a 4.0HP Motor which would have an Amperage Rating of about 14.0Amps on High Speed at 230V and Not applicable for 115V Pumps... It will also be a 56Frame motor which would have a 5/16" head on the through bolts.....

  This is a 1HP Impeller with a 2 1/8" Eye with 1/4" Vane Width and 3 7/8" OD for an Aqua-Flo 48 or 56 Frame Wet End 1.0HP Motor would be about 8.0 Amps on high speed at 230V or 12.0 Amps at 115V. This Impeller fits between the Face and the Volute...

This is a 230V Waterway Tiny Might Circulation Pump that is 1" x 1" which measures about 1 7/8" to the outside of the threads. It is high in efficiency and low on power use. Tiny Might packs a not-so-tiny punch. The Tiny Might offers you a great low flow...

This part is a Wear Ring for a Hi-Flo Impeller found in Waterway Hi-Flo pumps only.. The Inside Diameter of the wear ring is 1 13/16"...

This parts is an Executive 2" Threaded Face plate assembly (Which will measure about 3" Across the Threads) less the O-rings, Screws, Bleeder Plugs and other hardware needed to attach it to the volute..There is another version of the face with a 2 1/2"...