Pumps and Related Parts

This item is a 3/4HP Waterway HiFlo Pump Impeller "B".. If Your motor is 115V the amperage would be about 11 Amp if 230V it would be about 7 amps..Closed face impeller made for the Hi-Flo side discharge pump by Waterway Plastics. Rated at...

 Vico Ultima Ultra Flo or Ultra Jet Pump ImpellerClosed face impeller made for the Ultima and Ultra Flo spa pumps by Vico. Rated at 4.0hp,which is between 12 and 14 Amps.. it is used in an Ultima, Ultra Jet and/or Ultra Flo pump wet end, and must be...

NOTE: THIS PUMP HAS BEEN DISCONTINUED DUE TO IT BEING A PEICE OF JUNK!! The replacements for this pump are  34-402-5252 or 34-402-5250       Complete Pump Type Portable Spa Pump Speed 2 Speed (2-Spd) Motor...

This part is an Aqua-Flo XP2 Impeller for a 2.0HP Motor which would have an Amperage Rating of about 10.0Amps on High Speed at 230V and 16.0 Amps on High Speed at 115V... It will also be a 56Frame motor which would have a 5/16" head on the through bolts...

This is a .75HP or 3/4HP Impeller for an Aqua-Flo 48 Frame Side or Center Discharge FMHP, FMCP, FMVP, and TMCP Series Wet End .75HP Motor that has about 7.0 Amps on High Speed at 230V and 7-8.0 Amps at 115V. This Impeller fits between the Face and the...

This part is a Stationary Switch that fits in the back of some A. O. Smith Motors also Century and Regal Beloit.. This switch is about 2" wide, 2 1/2" Long and 1 3/8" Tall.. Motor Brand    A.O.Smith/Regal BeloitMotor Parts Type  ...

Vico, Ultimax Pump ImpellerClosed face impeller made for the Ultimax spa pump by Vico. Rated at 3.0hp,which would be 8-10.0 Amps.. it is used in an Ultimax pump wet end, and must be installed on a 2.0hp (or greater) thru bolt motor.  Click here for...

Gemini Plus II Pump Complete with Wet End and Air Switch... 1 1/2" X 1 1/2" which measures about 2 3/8" across the threads.. Specifications are 1.5 HP 115Volt 12.5Amps... For high flow bath jet systems Length = 12-11/16" Width = 5-11/16" Discharge...

Start Capacitor1-7/16"dia x 2-3/4"hgt

This parts is an Executive 2 1/2" Mpt Threaded Face plate assembly (Which will measure about 3 11/16" Across the Threads) less the O-rings, Screws, Bleeder Plugs and other hardware needed to attach it to the volute..There is another version of the face...

This Pump is a 48Frame 230V 2 Speed with a 1.0 HP Wet End that features a 2" x 2" inlet and outlet Wet End that measures about 3" across the threads...  High speed Amperage is 7.7 and low speed is 2.2 Amps..   Spa Pump Features: Fine tuned...

Start Capacitor1-7/16"dia x 2-3/4"hgt