Pumps and Related Parts

This Listing is for a Waterway Executive 16.4 Amp 56fr 2 Speed 230V 5 HP 2" X 2" Pump. Your sticker may say 5-6HP. This unit features a 2" X 2" Executive Wet End that can be moved from the 12 O'clock position to the 3, 6, or 9 O'clock position and a...

Start Capacitor1-7/16"dia x 2-3/4"hgt

This part is a Impeller, Jacuzzi, J Pump, 1.0hp, 48FR, J Series, JCM Series, K Series, KM Series.. This is found on a Wet End that has a face like I show in the Photo Section only..  Impeller Type Closed Face Impeller Diameter...

Waterway Hi-Flo Pump ImpellerClosed face impeller made for the HiFlo side discharge pump by Waterway Plastics. Rated at 1.5hp, it is used in a Waterway Hi-Flo pump wet end, and must be installed on a 1.5hp (or greater) thru bolt motor. Shaft seal...

This Jet Pump is found from the factory in many hot tubs and will be an easy installation for people who are handy.   This pump is a 56 frame XP2e 3.0HP 230V Side Discharge wet end with a 2" suction side and 2" pressure side which measures about 3"...

This impeller fits a Universal CMP Brand 3HP Wet End only and it requires a Special Seal that you will find a link to below.. This impeller may also have any of the following manufacturer part numbers stamped on the back: 27203-300-300, 27203-000-300, or...

This part is a Complete 2HP Aqua-Flo 2" x 2" ( Which measures about 3" Across the Threads) Side discharge 48 frame wet end for XP2 pumps. This wet end is used with a 48 frame motor that would have about 10.0 Amps on High Speed on a 230V motor or 16.0...

This Pump is a 48Frame 230V 2 Speed with a 3.0 HP Wet End that features a 2" x 2" inlet and outlet Wet End that measures about 3" across the threads...  High speed Amperage is 13.1 and low speed is 3.3 Amps.. Note: This pump and motor come without...

This part is an Aqua-Flo XP2 Impeller for a 3.0HP Motor which would have an Amperage Rating of about 12.0Amps on High Speed at 230V and Not applicable 115V Pumps... It will also be a 56Frame motor which would have a 5/16" head on the through bolts... If...

This part is an Aqua-Flo XP2 Impeller for a 2.5HP Motor which would have an Amperage Rating of about 11.0Amps on High Speed at 230V and is Not Applicable for 115V Pumps... It will also be a 56Frame motor which would have a 5/16" head on the through...

This Kit is an 2HP Impeller for an Executive 48 Frame Wet End up to 2HP Motor and a 56 Frame Wet End 2 HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you...