Pumps and Related Parts

This part is a Pump Face for a Vico Ultima Side Discharge wet end that is 2" which measures about 3" edge to edge across the threads.. The Seal Kits for this pump can be found here: Vico Seals 201 The other parts for this pump can be found here: Ultima...

This part is a Complete FMHP 1.0HP Aqua-Flo 1 1/2" x 1 1/2" (Which measures about 2 3/8" Across the Threads) Side discharge 48 frame wet end for FMHP pumps. This wet end is used with a 48 frame motor that would have about 8.0 Amps on High Speed on a 230V...

This Waterway 2.0hp Ex2 Pump is 230v, 2-spd, 48fr, 9.0A, 2"x 2" and it is a perfect XP2 Replacement.. This is Waterways answer to an Xp2 pump.. Manufacturer Waterway Pump Model EX2 Speed 2 Speed (2-Spd) Motor Voltage 230v Drain Plug Location...

// As Of 08-24-2021 We have these in stock ready to ship..    Pump, Circulation, Aqua-Flo CMHP, 1/15hp, 230v, 1-1/2" Side Discharge   This 230V Laing E-14 circulation pump is compact and lightweight, less than 5 lbs. The E14...

You are buying a 1" FTB X 3/4" Barb Pump Union with O-ring that matches the Union.The Union receives a 3/4" Inside Diameter Hose which measures about 1" on the outside and then Screws to a 1" Wetend (Pump) Threaded Part on the other side the threads will...

This is the Ninja whirlpool bath pump from CMP. Used by many tub makers over the years. 115v, 10.0 Amps, comes with air switch and 36" Nema cord. Also available in other amperages. Length Width Discharge Height Overall Height 13.64" 5.35" 6.75" 7...

This part is a 2.5HP Sta-Rite DJ Dura-Jet Pump Impeller.. This impeller will usually have the number 17400-0123 cast into the back and will measure about 3 3/4" wide with an eye width of 1 3/4" and a vane width of 1/2".. This can be found on motors with...

This is a 4HP Impeller with a 2 1/8" Eye a 1/2" Vane Width and a 4 1/2" OD for an Aqua-Flo 48 or 56 Frame Wet End 4.0HP Motor which would have about 14.0A on high speed. This Impeller fits between the Face and the Volute of an Aqua-Flo XP2 or FMXP2 Wet...

Waterway HiFlo Pump ImpellerClosed face impeller made for the HiFlo side discharge pump by Waterway Plastics. Rated at 2.0hp, it is used in a Waterway HiFlo pump wetend, and must be installed on a 2.0hp (or greater) thru bolt motor. Shaft seal sold...

This part is a Complete XP2e 6.3” 4.0HP Aqua-Flo 2" x 2" ( Which measures about 3" Across the Threads) Side discharge 56 frame wet end for XP2e pumps. This wet end is used with a 56 frame motor that would have about 14.0 Amps on High Speed on a...