Pumps and Related Parts

Vico/Balboa Ultima/Ultra Flo Pump ImpellerClosed face impeller made for the Ultima and Ultra Flo spa pumps by Vico/Balboa. Rated at 3/4hp, it is used in an Ultima and/or Ultra Flo pump wet end, and must be installed on a 3/4hp (or greater) thru bolt...

This pump is a Verticle or Horizontal Mount Aqua Flo Circ Master HP 115 Volt Pump 1/15 HP 1.3 Amps 1 Speed Inlet and outlet measure 2-3/8" outside diameter which is called 1 1/2".. The front Suction side is side discharge and can be turned in 4...

This part is a Complete Flo-Master FMCP 1HP Aqua-Flo 1-1/2" x 1-1/2" ( Which measures about 2 3/8" Across the Threads) Center discharge 48 frame wet end for 48FR pumps. This wet end is used with a 48 frame motor that would have about 8.0 Amps on High...

This Listing is for a (1) Speed Waterway Executive 56fr 230V 3 HP 2" X 2" Pump. Your sticker may say 4HP but based on the chart it is really a 3HP at 12 Amps. Measure the intake and pressure side threads and match them up before ordering.  This unit...

This Pump is a 48Frame 115V 2 Speed with a 1.0 HP Wet End that features a Side Discharge 1 1/2" x 1 1/2" inlet and outlet Wet End that measures about 2 5/16" across the threads...  High speed Amperage is 9.5 and low speed is 3.2 Amps..  ...

Start Capacitor1-7/16"dia x 2-3/4"hgt

This pump is a Waterway Genesis Generation Energy Efficient Bath Pump 9.5 amps 115 Volts w/Air Switch The Plumbing connections are 1 1/2" on the Pressure and Suction sides which measure about 2 3/8" across the threads.. There are two barbed fittings on...

This 230V Laing E-10 pump with a 1" Barb Suction and Pressure Side which measures about 1" Outside Diameter and the hose is 1" Inside Diamater  is compact and lightweight, less than 5 lbs. It is whisper quiet, highly efficient and designed with...

Half Union Fitting Complete Set... The Threaded side measures about 2 3/8" Inside and the Slip Glue end measures about 1 7/8" Inside Diameter... Note: Although this measures very much like a 1 1/2" x 1 1/2" Slip pump union it only fits Hayward Pumps...

This part is an Impeller for a Sta-Rite DuraJet DJ Wet End that would be called 1.0hp-1.5HP, your motor should be 8.0-9.0Amp at 230V or 16.0 Amps at 115V.. The number on the back of the impeller will be 17400-0121 if you have a number on yours.. ...

This complete pump is a Waterway, Executive, 1.0hp, 115v, 2-spd, 48fr, 2"...Spa Pump Features:Executive wet end designed specifically for 48-frame motorsLarge 6-1/2" diameter wet end for higher head pressure2" intake and dischargeWet end can be rotated...