Pumps and Related Parts

Start Capacitor1-7/16"dia x 2-3/4"hgt

You are buying a 2 HP 48 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and the Wear Ring. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will be 3...

This part is a Complete XP2e 6.3” 2.5HP Aqua-Flo 2" x 2" ( Which measures about 3" Across the Threads) Side discharge 56 frame wet end for XP2e pumps. This wet end is used with a 56 frame motor that would have about 11.0 Amps on High Speed on a...

The Waterway Executive 48 pump is thermally protected to extend the life expectancy of the motor with a highly versatile wet end.Spa Pump Features: Executive wet end designed specifically for 48-frame motors Large 6-1/2" diameter wet end for higher head...

This pump is a 115V 48 Frame 2" X 2" Waterway Executive (2) Speed 1.5HP 13.3Amp on High and 4.1A on Low..  The Pressure and Suction sides measure about 3" edge to Edge across the threads..  The Waterway Executive 48 pump is thermally protected...

This part is No Longer Available if you need a face you will have to choose a complete wet end..  This part is a Face Plate with Drain Plugs and Face O-Ring that fits Aqua-FLO XP2E wet ends only on the back of the face where the wear ring will touch...

Start Capacitor1-7/16"dia x 3-7/8"hgt

Waterway HiFlo Pump ImpellerClosed face impeller made for the HiFlo side discharge pump by Waterway Plastics. Rated at 3.0hp, it is used in a Waterway HiFlo pump wetend, and must be installed on a 3.0hp (or greater) thru bolt motor. Shaft seal sold...

Vico/Balboa Ultimax Pump ImpellerClosed face impeller made for the Ultimax spa pump by Vico/Balboa. Rated at 4.0hp, it is used in an Ultimax pump wet end, and must be installed on a 4.0hp (or greater) thru bolt motor. Click the below links for the seals,...

You are buying a 3 HP 48 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and the Wear Ring. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will be 3...

This part is a Wear Ring measures 2 5/8" inside Diameter and fits all Aqua-Flo XP2e and Xp3 Impellers except the 3.0HP Xp2e Impeller... The Odd 3.0HP Impeller requires a different Wear Ring which measures 2 3/8" Inside Diameter.. Look at the chart in...

This is a 115V Center Discharge Aqua-Flo Circulation pump with a 1 1/2" Suction and Pressure side that measures about 2 3/8" Across the threads. Circ-Master pump takes 24-hour filtration to a new level, delivering the highest GPM of any recirculation...