Pump Wet Ends and Related Parts

This kit is a Set of (2) Air Bleeder barbed plugs and Silicon sealer usually used on a Dynasty Hot Tub with Waterway Hot Tub Pump Face to bleed the air off the pump while filling the tub up. I have seen these fittings in many brands just compare the...

This Part is a Barbed Bleeder Barb with O-Ring that fits New Style 48 or 56 Frame WUA Intertek LX Brand Pump Wet End that uses a fine thread bleeder plug.. Watch the video for instruction on how to install this part and also how to...

This part is a Complete CMHP 1/15th HP Aqua-Flo 1 1/2" x 1 1/2" (Which measures about 2 3/8" Across the Threads) Side discharge 48 frame wet end for CMHP pumps. This wet end is used with a 48 frame motor that would have about .6 Amps on High Speed on a...

This Parts is a NON-Standard 2" Heater or Pump Union O-Ring that measures 2 5/8" Center to Center. The O-Ring is 2 5/8" center to center and fits some unions but most unions are 2 1/2" center to center... Do not buy this O-Ring until you...

NOTE: This Part will Fit Sundance® or Jacuzzi® Tubs with a Guangdong LX Wet End if you replace the entire Wet End for internal parts of the wet end you already have click here Jacuzzi® & Sundance® LX...

This part is a Front and Back Volute for a Vico, Ultimax, 2" X 2", 48 or 56fr motor.. This part will fit both 48 and 56 frame motors and does not come with any other accessories like the seal, bolts or impeller.. For other parts click this link for this...

This part is a Volute O-Ring, 6" ID, 3/32" Thick, Vico Ultimax, 48 or 56 Frame...

This Face Plate O-Ring Is 5 1/8" Inside Diameter and is 1/8" Thick. It is found on Aqua-Flo 1 1/2" x 1 1/2" (Which Measures 2 3/8" Outside of the threads on the Sunction and Pressure Side of the Wet End) These Wet Ends used the names Flo-Master,...

This Pump is a Perfect Replacement option for a Watkins 39578-03 Pump it is a 2.5 Horse Power 12.0/4.4 Amp (2) Speed 56 Frame Complete Pump. It is about 7 1/4"" across the face of the pump, it measures about 7 3/8" from the bottom to the top of the...

This Kit is a 3/8" Tubing Connection Kit for 3/8" Plumbing repairs where you are connecting old 3/8" Clear Tubing that measures about 1/2" OD between a cut air control line and the 3/8" Barb on an Air Manifold or Jet Body Air connection.. The kit...

  This part is a SWIM56-15 5 Horse Power 56 Frame Pump Bleeder with Silicone & Wet End fits Power-Rite Guangdong LX Brand SWIM56-15 Pump Motors only. These pumps usually have the part number Swim56-15 on the label. Watch the video...

For the bleeder barb for this wet end Click Here: Barbed Bleeder Plug for Guangdong LX 48 Frame Wet End Fine Threads Jacuzzi® or Sundance This part is aSWIM56-15 5 Horse Power 56 Frame Pump Wet End fits Power-Rite Guangdong LX Brand SWIM56-15...