Pump Wet Ends and Related Parts

This Seal is a (BEST) Silicon Carbide Salt Resistant Upgraded Version of a PS-201 Seal used Primarily in Vico, Sta-Rite and Power Right Wetends. Silicon Carbide’s exceptional wear and chemical resistance, enhanced dry running capability and high...

This Seal is The (BEST) Upgraded Salt Resistant Silicon Carbide Version a PS-200 Seal used Primarily in Aqua-Flo Wetends but is found in Waterway " Viper" & "EX2" Wetends and some others as well.. Silicon Carbide’s exceptional wear and...

You are buying (BEST) Silicon Carbide Salt Resistant Verison of a PS-1000 Seal. Silicon Carbide’s exceptional wear and chemical resistance, enhanced dry running capability and high hardness means it is an excellent choice for aggressive, corrosive...

You are buying a 1 1/2" Slip X 1 1/2" Pump Union with Gasket or Oring that matches Union. The Union recieves a 1 1/2" pipe or fitting on one side and then Screws to a 1 1/2" Wetend(Pump) Threaded Part on the other side. It will Glue to a 1 1/2" Pipe or...

Waterway Hi-Flo Wet EndSide discharge, 2"mbt suction/discharge, 48 frame wet end for the Waterway Hi-Flo pump. This wet end is used with a 1.5hp, 48 frame, thru-bolt style motor. The motor used may be either a single or dual speed. The wet end may be...

You are buying a 4 HP 48 Frame Waterway Executive 2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and the Wear Ring. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will be 3...

This part is a Complete 1HP Aqua-Flo 2" x 2" ( Which measures about 3" Across the Threads) Side discharge 48 frame wet end for XP2 pumps. This wet end is used with a 48 frame motor that would have about 8.0 Amps on High Speed on a 230V motor or 12.0 Amps...

This part is a Complete XP2e 6.3" 2HP Aqua-Flo 2" x 2" ( Which measures about 3" Across the Threads) Side discharge 56 frame wet end for XP2 pumps. This wet end is used with a 56 frame motor that would have about 10.0 Amps on High Speed on a 230V motor...

This item is a face is for a Sta-Rite DuraJet DJ pump... This face plate does come with the new style plugs in it.. Material Type Plastic Volute With Seal No Volute to Seal Plate Mounting Type 4 Bolts 4 Nuts Suction Connection (Physical...

This Kit is an 1HP Impeller for an Executive 48 Frame Wet End up to 1HP Motor and a 56 Frame Wet End 1HP Motor. This Impeller fits between the Face and the Volute of an Executive Wet End. I would advise replacing the Seal when you replace...

The Waterway center discharge wet end has been discontinued and replaced with the E-Series Center Discharge wet end by the manufacturer. Please be sure which wet end you have as the parts are not interchangeable. The easiest way to identify which wet end...

This part is a 2HP Sta-Rite DJ Dura-Jet Pump Impeller.. This impeller will usually have the number 17400-0122 cast into the back and will measure about 3 3/4" wide with an eye width of 1 1 3/4" and a vane width of 1/2".. This can be found on motors with...