Pump Wet Ends and Related Parts

This is a 4HP Impeller with a 2 1/8" Eye a 1/2" Vane Width and a 4 1/2" OD for an Aqua-Flo 48 or 56 Frame Wet End 4.0HP Motor which would have about 14.0A on high speed. This Impeller fits between the Face and the Volute of an Aqua-Flo XP2 or FMXP2 Wet...

Waterway HiFlo Pump ImpellerClosed face impeller made for the HiFlo side discharge pump by Waterway Plastics. Rated at 2.0hp, it is used in a Waterway HiFlo pump wetend, and must be installed on a 2.0hp (or greater) thru bolt motor. Shaft seal sold...

This part is a Complete XP2e 6.3” 4.0HP Aqua-Flo 2" x 2" ( Which measures about 3" Across the Threads) Side discharge 56 frame wet end for XP2e pumps. This wet end is used with a 56 frame motor that would have about 14.0 Amps on High Speed on a...

This item is a 48 Frame Vico Wet End with 2" x 2" inlet and outlet that would measure about 3" across the threads and it has a 2.0HP impeller which would fit a motor that has 10.0 amps at 230V and 16.0 amps at 115V.. Pump to Motor Foot Types  ...

You are buying a 5 HP 56 Frame Waterway Executive 2 1/2" X 2" Wet End / Pump complete with Screws, Volute, Impeller, Seal, Face and the Wear Ring. The difference between a 48 or 56 Frame wet end is the spacing of the Motor Thru bolts. The 48 Frame will...

This part is a 48Frame Center Discharge 1 1/2 x 1 1/2" 1HP Waterway Wet End.. The threads would measure about 2 3/8" Edge to Edge.. This wet end would be found on a 115V motor with an Amperage of about 12 Amps or a 230V motor with an Amperage rating of...

This Wet End is a 2" x 2" 3.0HP 48 or 56 frame Ultimax Vico® that would normally be found an a 230V pump with 12.0 Amps High speed there are no 115v versions of this wet end..  This side discharge, 2" x 2" mbt which would measure about 3" edge...

This part is a Complete FMHP .75HP Aqua-Flo 1 1/2" x 1 1/2" (Which measures about 2 3/8" Across the Threads) Side discharge 48 frame wet end for FMHP pumps. This wet end is used with a 48 frame motor that would have about 7.0 Amps on High Speed on a 230V...

The Waterway center discharge wet end has been discontinued and replaced with the E-Series Center Discharge wet end by the manufacturer. Please be sure which wet end you have as the parts are not interchangeable. The easiest way to identify which wet end...

This part is an Aqua-Flo XP2 Impeller for a 1.5HP Motor which would have an Amperage Rating of about 9.0Amps on High Speed... It will also be a 56Frame motor which would have a 5/16" head on the through bolts... If you have 1/4" head you probably need...